Description
Overview
As per FORD FMC1278 and EMC-CS-2009.1 a part of the test pulses is not generated using a transient pulse generator similar to the ones defined as per ISO 7637 but being based on a circuitry including a Potter & Brumfield 12VAC relay and specifically defined components such as inductors, capacitors, resistors and switches with the aim of simulating "real-world transients".
The EM TEST RCB 200N1 transient generator meets the requirements set out by the FORD FMC1278 and EMC-CS-2009.1 standard document. It is built using the components outlined in Figure F-1 to generate pulses such as CI 220 A1, A2-1, A2-2, C-1 and C-2, CI 260 F and RI 130 A2-1 and A2-2 for which the RCB 200N1 is built into a metal housing. For RI 130 testing the RCB 200N1 offers BNC-type coaxial outputs to connect the specified test fixture needed for this particular test.
Data SheetUser ManualSpecifications
Common Standards |
FORD FMC1278 & EMC-CS-2009.1 Jaguar EMC-CS-2010JLR V1.1 (2011-01) & JLR-EMC-CS V1.0 Amd 4 |
TECHNICAL DATA |
|
RCB 200N1 |
Circuitry as per Annex F, Figure F-1 with the following components: |
Resistor R1 |
51 ohms, 25W |
Resistor R2 |
220 ohms ± 5%, 2W |
Resistor R3 |
33 ohms ± 5%, 10W |
Resistor R4 |
6 ohms ± 5%, 50W |
Capacitor C1 |
100 nF capacitor, 400V |
Inductor L1 |
5 uH inductor (Osborne transformer part no. 8745) |
Inductor L2 |
100 mH inductor (Osborne transformer part no. 32416) |
Diode D1 |
Zener diode, 39V, 5W |
Transistor Q1 |
NPN transistor |
SW0 - SW4 |
Single Throw Switch |
RLY1 |
12 volt AC relay, NC contact used (Potter&Brumfield KUP-14A15-12) |