ETS-Lindgren/EMCO 3810/2NM - Rent 50µH 10Amp LISN

10Amp ETS-Lindgren LISN:

  • Frequency Range: 9 kHz to 30 MHz
  • Inductors: 250 & 50 Microhenry (air-core)
  • Compliant to FCC 15 B & CISPR 11, 32/22
  • Maximum DUT/EUT 10Amps/125 VAC
  • Typically Rented with Transient Limiter


Get weekly, two week, and monthly rentals on all products

Got Questions about the equipment? Get technical support

Two FREE days transit time with every rental

Request A Quote

Associated Rental Emissions Equipment



The ETS-Lindgren Model 3810/2 Line Impedance Stabilization Network (LISN) is a two-channel low pass filter network designed to isolate the Equipment Under Test from an external power source while steering any radio frequency signals from the power line to a 50-ohm port.

The Model 3810/2 Line Impedance Stabilization Network (LISN) is designed for use in Installation Category II and Pollution Degree II per lEC-1010 and IEC-664. When installing in a cabinet, make sure that the convection around the product is not restricted. The ambient temperature outside the cabinet must be less than the maximum operating temperature of the Model 3810/2 by 4°C for every 100 watts dissipated in the cabinet. If the total power dissipated in the cabinet is greater than 800 watts, then forced convection must be used.

The Model 3810/2 is nominally designed for a 10 ampere current capacity. Maximum line-to-line voltage must not exceed the voltage rating of the power outlet provided on the front panel.

Data SheetUser Manual


Common Standards

CISPR 16-1-2, ANSI C63.4


50Ω / 50 μH + 5Ω (CISPR), 50 μH & 250 μH(ANSI)

Frequency Range

9 kHz to 30 MHz

Insertion Loss (Voltage Division Factor)

9 kHz - 150 kHz <6.5 dB to <0.5 dB (increasing linearly with log of freq)

150 kHz - 30 MHz <0.5 dB


9 kHz - 150 kHz >10 dB to >60 dB (increasing linearly with log of freq)

150 kHz - 30 MHz >60 dB

Voltage Rating

270 VoltsAC (rms), 380 VoltsDC (Line to Ground)

Current Rating

20 AmpsAC (rms), 14 AmpsDC

You may also like

Recently viewed