Amplifier Research 150W1000B
Included Accessories
Can't find something? Contact UsRelated Equipment
Description
The Model 150W1000B is a solid-state, Class A design, self-contained, aircooled, broadband power amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. It will provide a minimum of 130 W across its operating bandwidth. Protection from input overdrive beyond 0 dBm is provided as well as protection from various failure conditions including over-temperature and power supply faults.
A front panel display indicates the operational status and fault conditions. All amplifier control functions, and status indications are available remotely using GPIB/IEEE-488, RS-232, fiber-optic serial, USB, or Ethernet. Interface connectors are located on the back panel. Local and remote operation is managed by a switch on the front panel.
Due to the Class A design it is ideally suited for EMC Test applications where continued operation into high VSWR loads including open and short circuits is required.
The export classification for this equipment is EAR99. These commodities, technology or software are controlled for export in accordance with the U.S. Export Administration Regulations. Diversion contrary to U.S. law is prohibited.
- Electrical Specifications:
- Rated Power Output (80 - 1000 MHz) PSAT
- 130 W Minimum
- Input for Rated Output Pin
- 1 mW / 0 dBm
- Power Output @ 1 dB Compression P1dB
- 100 W Minimum
- Power Output @ 3 dB Compression P3dB
- 125 W Minimum
- Operating Frequency BW
- 80 MHz Minimum
- Gain (Small Signal)
- 53 dB Minimum
- Gain Reduction Adjustment
- 20 dB Minimum
- Flatness
- 1.5 +/- dB Minimum
- Input Impedance Z in (50 Ohm)
- 1.5:1 VSWR Maximum
- Output Impedance Z out (50 Ohm)
- 2.5:1 VSWR Maximum
- 3rd Order Intercept IP3
- 58 dBm
- Noise Figure NF
- 8 dB Maximum
- Harmonic Distortion @ 100 W H2, H3
- Negative 20 dBc
- Spurious
- Negative 73 dBc
- Power Consumption PD
- 650 W Maximum
- Mechanical Specifications:
- Dimensions (With Cabinet) (W x H x D)
- 19.8 x 8.1 x 29.5 in
- Dimensions (No Cabinet) 4U for 19 Inch Rack
- 19.0 x 7.0 x 29.5 in
- Weight (With Cabinet)
- 81 lb
- Weight (No Cabinet)
- 56 lb
- Cooling
- Forced air (self-contained fans)
- Connector interfaces:
- RF input
- N female (50 ?)
- RF output
- N female (50 ?)
- IEEE-488
- 24-pin female
- RS-232
- 9-pin subminiature D female
- RS-232 (fiber optic)
- ST
- USB 2.0
- Type B
- Ethernet
- RJ-45
- Interlock
- 15-pin subminiature D female
info@transientspecialists.com