MIL-STD-461 CS101 Rentals - Conducted Susceptibility Test Equipment

Power Sweep Tester

In Stock

Power Sweep Features 

      • Manual or Automatic Freq Sweep 20Hz-150KHz
      • Digital Display Frequency & Voltage or Injection Level
      • Free Technical Support & 2 Days Free Transit
      • Remote Sensing of Voltage Injected Into EUT 
      • Automatic Leveling of Output Voltage
      • Turnkey Solution - Arrives Ready for Testing!

Overview

The Solar 8850 by Solar Electronics is a power sweep generator with 7021-1 phase shift network for Mil Std 461 CS01/CS101. A2LA accredited calibration is included in the EMC rental equipment price. This product is ideal for conducted susceptibility testing providing increased audio voltage from a low impedance source.

This Military EMC Test Equipment is designed to be used with an audio isolation transformer allowing the injection injection of sinewave audio voltages into power lines supplying the EUT.  The Solar 8850 offers the option for both manually tuned or sweeping mode for four frequency bands 20Hz to 150Khz. The digital display on this EMC test equipment shows frequency and output voltage level(injection voltage level).

The Solar 8850 also provides automatic leveling of output voltage as frequency is scanned or swept. This product is designed to meet the testing critera for MIL-STD-461 CS101 and MIL-STD-461 CS01. The maximum output of this test equipment is 300 watts for 1.5 ohm resistive load  and 200 watts for a 2.5 ohm. As added protection this Solar military product provides protective circuits preventing damage caused by power frequency feedback in typical a.c. setups. 

Feed-Thru Capacitors

In Stock

Feed Thru Cap Features 

      • High Insulation Resistance - Wide Range
      • Capacitance 10µF, Max 600V
      • Built-in discharge resistor for safety
      • Designed for bulkhead or bench mounting
      • Turnkey Solution - Arrives Ready for Testing!

Overview

The 6512-106R by Solar Electronics are a series of 10µF Feed-Thru Capacitor, ideal for military/avionic RFI/EMI test setups such as MIL-STD-461A/462A and are rented in sets of 2. A2LA accredited calibration is included in the EMC rental equipment price. In this application the capacitor provides a low RF impedance across the power source so that EMI currents produced by the equipment under test can be accurately measured with a current probe.

Audio Power Transformer

In Stock

HV Isolation Transformer 

      • High current Secondary 1/4-20 Threaded Studs
      • MIL-STD-461 CS101 CS109
      • Primary Less than 5Ω & ¼ the primary impedance 
      • Free Technical Support & 2 Days Free Transit

Overview

The 6220-4 / Solar6220-1B by Solar Electronics audio isolation transformer allows testing for DO-160 Sec 18,sec 20. The transformer is capable of handing up to 200 W of audio power into its primary over the frequency range 30 Hz to 250 kHz. The turns ratio provides a two-to-one step down to the special secondary winding. The secondary will handle up to 50 A of AC or DC without saturating the transformer.

Another secondary winding is connected to a pair of binding posts suitable for connecting to AC voltmeter as directed by the applicable EMI specifications.The transformer may be used as a 4 Ω primary and 1 Ω secondary or 2.4 Ω primary and 0.6 Ω secondary or 2 Ω primary and 0.5 Ω secondary.

800 W Isolation Transformer

In Stock

Isolation Transformer Features 

      • Designed for MIL-STD-461 CS 06 
      • Rated at 800 W, 50-60 Hz
      • Turnkey Solution - Arrives Ready for Testing!

Overview

The Solar7032 is an electronics power line isolation transformer for MIL-STD-461 CS06 and MIL-STD 1399. This transformer is equipped with a wall plug and 2 binding posts. Rated at 800 W, 50-60 Hz. There are times when it is necessary to step up the power line voltages from 115 V to 230 V. This transformer is equipped with a male connector on the 115 V winding and a female connector on the 230 V winding. The connectors are the international style IEC-320/CEE 22. Mating plugs not supplied. Rated at 800 W, 50-60 Hz.

Line Impedance Stabilization Network

In Stock

LISN Features 

      • Frequency Range 10 kHz – 50 MHz
      • Current Rating 50 Amps; Inductance 50 μH 
      • Coupling Capacitor . 0.25 µF
      • Used for a Variety of MIL-STD-461 Testing
      • Turnkey Solution - Arrives Ready for Testing!

Conducted Susceptibility Testing Power Leads (30 Hz to 150 kHz)
Conducted Susceptibility Testing Power Leads (30 Hz to 150 kHz)
MIL-STD-461 CS101 section of MIL-STD-461 puts forth requirements for conducted susceptibility for power leads. This standard applies interference to the power input of the electrical or electronic equipment. Testing for this military standard applies from 30 Hz to 150 kHz for equipment with current draws less than or equal to 30 Amperes per phase. It also applies to electrical systems that draw more than 30 amps if it has a operating frequency of 150 kHz or less. This standard also defines what constitutes a pass and failing criteria. CS101 is broken down into applicability, limit, and test procedure.  MIL-STD-461 CS101 Power Limit all applications
For MIL-STD-461 CS101 testing we offer rentals of the Solar Electronics 8850 military power sweep generator. This generator is designed for both this standard and MIL-STD-461 CS01. All of our military susceptibility test equipment rentals come with an accredited calibration and free technical support included in the rental price. This cost efficient solution offers easy to use interface which allows test parameters to be modified via front panel turn nob. The equipment for this standard includes, a signal generator, power amplifier, oscilloscope, coupling transformer, 10 μF capacitor, isolation transformer for oscilloscope use, 0.5 ohm Resistor, and LISNs.  MIL-STD-461 CS101 General Test setup for non-conductive