Up to 4 Free Days of Transit Time
Two transit days each way are excluded from rental period
ETS-Lindgren/EMCO 3810/2NM
Rent 50µH 10 Amp LISN
In Stock & Ready To Ship
Orders by 3pm ship today
Features
- Frequency Range: 9 kHz to 30 MHz
- Maximum 10 Amps 125 Volts AC
- Inductors: 250 & 50 Microhenry (air-core)
- Compliant to FCC 15 B & CISPR 11, 32/22
- Current ISO 17025 Accredited Calibration
Description
The ETS-Lindgren Model 3810/2 Line Impedance Stabilization Network (LISN) is a two-channel low pass filter network designed to isolate the Equipment Under Test from an external power source while steering any radio frequency signals from the power line to a 50-ohm port.
The Model 3810/2 Line Impedance Stabilization Network (LISN) is designed for use in Installation Category II and Pollution Degree II per lEC-1010 and IEC-664. When installing in a cabinet, make sure that the convection around the product is not restricted. The ambient temperature outside the cabinet must be less than the maximum operating temperature of the Model 3810/2 by 4°C for every 100 watts dissipated in the cabinet. If the total power dissipated in the cabinet is greater than 800 watts, then forced convection must be used.
The Model 3810/2 is nominally designed for a 10 ampere current capacity. Maximum line-to-line voltage must not exceed the voltage rating of the power outlet provided on the front panel.
- Specifications:
- Type
- 50 Ohm / 50 uH + 5? (CISPR), 50 uH & 250 ?H(ANSI)
- Frequency Range
- 9 kHz to 30 MHz
- Insertion Loss (Voltage Division Factor)
- 9 kHz - 150 kHz <6.5 dB to <0.5 dB (increasing linearly with log of freq)
- 150 kHz - 30 MHz <0.5 dB
- Isolation
- 9 kHz - 150 kHz >10 dB to >60 dB (increasing linearly with log of freq)
- 150 kHz - 30 MHz >60 dB
- Voltage Rating
- 270 VoltsAC (rms), 380 VoltsDC (Line to Ground)
- Current Rating
- 20 AmpsAC (rms), 14 AmpsDC
Rent the ETS-Lindgren/EMCO 3810/2NM
Weekly, two-week and monthly rentals available.
Related Conducted Emission Equipment
Compare LISNs, current probes, transient limiters, EMI receivers, and spectrum analyzers for conducted emissions. Select by frequency range, current rating, standards, and requirements.
info@transientspecialists.com