GMW 3172
- 10 Ohm & 100 Ohm Power Calibration Loads
- Designed for up to 48 Volt Battery Lines
- Low Inductive, High Precision Load Resistor
- -60 to +60 Volts 100 Amps Continuous
- Pulses 4 and 2b (ISO 7637-2/ISO 16750-2)
- Extended Range 80 Volts 80 Amps
- -60 to +60 Volts 10 Amps Continuous
- Pulses 4 and 2b (ISO 7637-2/ISO 16750-2)
- Four Quadrant, Bipolar Amplifier
- 4-channel Arbitrary Waveform Generator
- 2-channel Transient Waveform Recorder
- Simultaneous Recording/Generation
- Frequency response 10 Hz to 500 kHz
- Audio power up to 3 x 200 W
- Turns ratio 2:1 step down
- Output Max. 160 V p-p, 50 V rms
- Output Current Max. 18 A rms
- Automatic Closed Loop Test Procedures
- Teseq ISO 7637-3 ICC for NSG 5500 System
- Used for Injection of Pulse 2A
- Includes CIP 9136A, PCJ 9201, & INA 5580
- Teseq ISO 7637-3 ICC for UCS 200N Series
- Used for Injection of Pulse 2A
- Includes CIP 9136A, PCJ 9201, & MN-CIP9136
- -60 to +60 Volts 50 Amps Continuous
- Pulses 4 and 2b (ISO 7637-2/ISO 16750-2)
- Extended Range 80 Volts 40 Amps
- Many pulses of LV124/Other OEMs (100A)
- Includes - Accessory Kit, Autowave & PA 5840
- Rent PFM200N100 for Additional OEM Pulses
- Provides LV124 E-01 to E-15 Pulses
- DUT Capabilities up to 100 Amps
- Includes Software & Verification Kits
- 10 Ohm & 100 Ohm Power Calibration Loads
- 1 Ohm & 1000 Ohm Data Line Calibration Loads
- Designed for up to 48 Volt Battery Lines
- Includes NSG 5500, PA 5840, & CDN 400
- ISO 7637-2 & ISO 7637-3 Tests
- Battery Simulators up to 60 V 100 A
- Switch for Power Lines 100 A and Data Lines 2 A
- Fast Switch with Rise/Fall Times of 200ns
- Pulses E10 and E13 of the LV 124/LV 148
- Calibration Kit Designed for EM Test Systems
- Compliant to IEC 61000-4-4 & ISO 7637, Annex D
- Includes KW 50 (50Ω) & KW1000 (1kΩ)
- -15 to +60 Volts 25 Amps Continuous
- High Bandwidth up to 150 kHz
- 75 Amps Inrush Current Capability
