EMC/EMI Test Accessory Rentals - CIP, Setups, & Monitoring Devices
CDNs, Clamps, Injection Devices
Coupling Decoupling
Probes & Monitoring
HV Probes, Voltmeters, Etc.
ESD Test Accessories
Voltmeters, Tips, Targets
Automotive Accessories
Clamps, Networks, Setups
MIL-STD-461/DO-160 Equipment
CIP, LISN, Fixtures, Packages
Current Injection Probes
CIP & Fixtures BCI
- IEC 61000-4-4 & IEC 61000-4-18 Compliant
- Designed for Coupling to I/O Lines
- Useable for Damped Oscillatory Wave Testing
- Vertical Coupling Plane for IEC 61000-4-2
- Includes one Bleed Off Cable with Resistors
- Wood Stand with Tightening Clamp Included
- Frequency Range: DC
- Max 63 V AC or 100 V DC (200 mA per Line)
- Rented with Common Mode Test System
- Frequency Range: 15 Hz to 150 kHz
- Max 63 V AC or 100 V DC (200 mA per Line)
- Rented with Common Mode Test System
- 100 Watts Max Audio Power (30 Hz to 250 kHz)
- Max 50 Amps AC or DC w/out Saturation
- Compliant to MIL-STD-461 CS101/CS109
- 10 Ohm & 100 Ohm Power Calibration Loads
- Designed for up to 48 Volt Battery Lines
- Low Inductive, High Precision Load Resistor
- Requires Two Channels of Autowave
- Designed for GMW3172 Superimposed Voltage
- Configured using autowave.control Software
- Single Phase Motor Variac
- Capabilities for Voltage Dips & Variations
- Maximum 260 Volts 16 Amps AC
- Maximum Level up to 1,200 A/m
- Input Voltage Drives H-Field Level
- Used with External Power Source
- 2000 A AC + DC true-rms, 1400 A AC, & 2000 A DC
- 2.3 Inch Jaw Size (Fits Around Most Atennas)
- Includes Current ISO 17025 Calibration
- Frequency 10 kHz - 400 MHz
- Internal Diameter of 32 mm
- Includes FCLCE-1000 Calibration Fixture
- Frequency 4 kHz - 400 MHz
- Includes PCJ 8201B Calibration Fixture
- Suitable for BCI Testing to ISO & MIL-STD
Overview
General Accessory Information
Accessories and associated equipment external of the main systems or equipment provides added capabilities and the ability to meet necessary test requirements. These can often be used to meet a specific section or requirement and may not be commonly used in conjunction with the system, making renting these accessories an ideal solutions. These can often be split up into many categories based upon application and use, often by active/passive use. Often times accessories are bundled into a package provide a complete solution for common testing.
Common Accessory Categories
- Monitoring Devices - Probes, Targets, & Verification Kits
- Injection Devices - CIP, CDNs, & Clamps
- Unique Test Setup Requirements - GCP, Tripods, & LISNs
- External Active Test Generators - Transients, Variacs, & Transformers
