GMW3172 - Rental Automotive EMC Test Equipment
Load Dump Simulators
Test Equipment/Systems
Electrical Fast Transient
Automotive Pulse Generators
DC Battery Simulators
System Power Supplies
Turnkey System
Automotive Pulse Systems
All Automotive Equipment
Rental Test Systems
- Frequency Range 4 kHz - 400 MHz
- Compliant to IEC, ISO, & MIL-STD Tests
- High power handling (up to 1 kW)
- Provides LV124 E-01 to E-15 Pulses
- DUT Capabilities up to 100 Amps
- Includes Software & Verification Kits
- Many pulses of LV124/Other OEMs (100A)
- Includes - Accessory Kit, Autowave & PA 5840
- Rent PFM200N100 for Additional OEM Pulses
- Teseq ISO 7637-3 ICC for UCS 200N Series
- Used for Injection of Pulse 2A
- Includes CIP 9136A, PCJ 9201, & MN-CIP9136
- Max 1000 Volts 100 Amps DC (150 Amp Peak)
- ISO 7637-2, ISO 11452-4, & CISPR 25 Compliant
- Switch for Selecting Testing Requirements
- Teseq ISO 7637-3 ICC for NSG 5500 System
- Used for Injection of Pulse 2A
- Includes CIP 9136A, PCJ 9201, & INA 5580
- Output Max. 160 V p-p, 50 V rms
- Output Current Max. 18 A rms
- Automatic Closed Loop Test Procedures
- Electronic Switch, Artificial Network, & RS-Box
- BS 200N100 Electronic switch, 60V DC/100A
- AN 200N100 1,000V DC, 250V AC (up to 1kHz)
- Frequency response 10 Hz to 500 kHz
- Audio power up to 3 x 200 W
- Turns ratio 2:1 step down
- Max 1000 V/150 A DC or 500 V/150 A AC
- HV Compliant to ISO 7637-4 & CISPR 25
- Jumpers Provide LISN Path Configuration
- Max 1000 V/200 A DC or 700 V/200 A AC
- Includes HVSE 8600 Shielded Enclosure
- 5uH LISN in Accordance with CISPR 25
- Designed for use with Teseq HV-AN 150s
- Rugged Design using Stainless Steel
- Compliant to HV CISPR 12/25 & ISO 7637-4
- Designed for use with NNHV 8123-200
- Compliant to HV CISPR 25 & BMW GS 95025-1
- Rented with set of NNHV 8123-200 LISNs
- Electronic Switch Accordance with ISO 7637 Part 2
- Rented with EM Test Transient Emissions Set
- Max 60 Volts & 100 Amps Cont. (400A @ 200ms)
- Impedance 50 µH || 50 Ω
- Frequency Range 150 kHz – 30 MHz
- Maximum: 200 Amps 700 Volts AC
- 4-channel Arbitrary Waveform Generator
- 2-channel Transient Waveform Recorder
- Simultaneous Recording/Generation
Overview
General Overview
Rentals of electromagnetic comparability test equipment provide a cost-effective solution to occasional testing needs. This standard by General Motors puts forth the environmental and durability testing requirements for Electrical/Electronic components for both commercial and passenger vehicles. This standard can be purchased at the IHS Standards Store. It is divided up into several major sections including requirements, performance verification, analysis, and design validation (DV). This General Motors automotive Standard has the majority of EMC based testing requirements under the design validation section. Evaluations, unless otherwise specified, fall under the functional status classification system with five distinct criteria. All of our Automotive EMC Test Equipment meets requirements within the standard and comes with an A2LA accredit calibration.
Testing
This standard mandates testing for parasitic current, power supply interruptions, battery voltage dropout, Sinusoidal/Pulse Superimposed Voltage, Intermittent/Continuous Short Circuit to Battery & ground, and many other methods of evaluating an electrical systems immunity capabilities. GMW3172 for section 9.2.2 Power Supply Interruptions references test methods according to ISO 16750 and Reset behavior at voltage drop to GMW14082. ISO 16750 is also referenced several times though out this automotive standard as a baseline to which additional requirements are placed. Much of our automotive EMC test equipment rentals provide testing to a variety of standards, allowing for requirements of both General Motors and ISO to be met. Test levels are based on a code letter basis and each require specific test voltage. Table 6 below defines minimum and maximum voltages used measured at the connector of component used in specifying the component criteria. 
Test Equipment
GMW3172 rentals offer testing to this standard providing the required waveform and capability, while offering the equipment at a fraction of the cost of buying new or used. We carry automotive EMC test equipment by both EM test and Teseq, each providing unique testing abilities and interfaces. Our automotive test generators come with an A2LA accredited calibration and technical support should any issues arise. Our technical support provides prompt solutions from an expert helping to decrease the learning curve. We offer automotive rental equipment from Teseq and EM Test, including the NSG5500, PA5840, and LD200N, VDS200N, and LD200N combination. These automotive test generators often coming with a laptop to remove software issues during setup. 
