

Compliance West MegaPulse D5-PF - Rent Defibrillation Tester
- IEC 60601-2-25 and -2-27:2011 Generator
- Integrated Energy Measurement
- Output Voltage & Polarity From Front Panel
In Stock


Compliance West MegaPulse D8-PF - Rent Defibrillation Tester
- Compliant to IEC 60601-1-2-26
- Newest Model of D5-PF Series Testers
- Direct Energy Readout for Energy Reduction Test
In Stock


Compliance West MP-BB-001 - Medical Breakout Box
- Easily Connect Leads to Defib Generator
- Rented with MegaPulse D8-PF/D5-PF
- Connection Interlock to MegaPulse for Safety
In Stock


Conducted Transient Emissions Set ISO 7637-2 EM Test
- Electronic Switch, Artificial Network, & RS-Box
- BS 200N100 Electronic switch, 60V DC/100A
- AN 200N100 1,000V DC, 250V AC (up to 1kHz)
In Stock


Coupling NX7 bsr-3-690-125.3 - 125Amp 3-Phase Surge & EFT CDN
- Coupler for Surge, EFT, & Ringwave Pulses
- Max 125 Amps 690 V AC or 1,000 V DC
- Transient Generator Mounted in Rack


ECAT E510 Rental - 10kV Combination Wave Module
- 10 kV Combination Wave Surge Module
- IEC 61000-4-5 & ANSI C62.41 Compliant
- Must be Used with ECAT E103 Controller
In Stock


EM Test ACC - Rent Automotive Capacitive Coupling Clamp
- ISO 7637-3 & OEM Compliant Solution
- Accepts Cables up to 40mm Diameter
- Solution for Testing Shielded Signal Lines
In Stock


EM Test AMP 200N2 - Rent LF Signal & Amplifier DC - 500 KHz
- Output Max. 160 V p-p, 50 V rms
- Output Current Max. 18 A rms
- Automatic Closed Loop Test Procedures


EM Test AN 200N100 - Rent 100 Amp 5uH DC LISN
- Max 1000 Volts 100 Amps DC (150 Amp Peak)
- ISO 7637-2, ISO 11452-4, & CISPR 25 Compliant
- Switch for Selecting Testing Requirements
In Stock


EM Test AutoWave - Rent 2 Channel Waveform Generator
- 2-channel Arbitrary Waveform Generator
- Dual-Processor-Technology, 500kS/s sample rate
- Library of Standard Test Routines
In Stock


EM Test AutoWave-WR - Rent 4-Channel Generator & Recorder
- 4-channel Arbitrary Waveform Generator
- 2-channel Transient Waveform Recorder
- Simultaneous Recording/Generation
In Stock


EM Test BS 200N100 - Electronic Switch for Voltage Transient Testing
- Electronic Switch Accordance with ISO 7637 Part 2
- Rented with EM Test Transient Emissions Set
- Max 60 Volts & 100 Amps Cont. (400A @ 200ms)
In Stock


EM Test CA BS 200N - Load Impedance for BS 200N
- 0.6ohm / 50uH Load as per ISO 7637-2:2004
- Max Supply Voltage 28VDC
- Max Load Current 50A


EM Test CA EFT Kit - Rent EFT/Burst Pulse Verification Kit
- Calibration Kit Designed for EM Test Systems
- Compliant to IEC 61000-4-4 & ISO 7637, Annex D
- Includes KW 50 (50Ω) & KW1000 (1kΩ)
In Stock

EM Test CA ISO - Rent Resistor Kit for Load Dump Verification
- Includes all Required Load Resistor Values
- Resistors with very low inductance
- Highly accurate resistors (+/-1%)


EM Test CA LV 124 - Rent LV 124 Verification Kit for PFM 200N100
- 10 Ohm & 100 Ohm Power Calibration Loads
- 1 Ohm & 1000 Ohm Data Line Calibration Loads
- Designed for up to 48 Volt Battery Lines
In Stock