ISO 7637 Test Equipment Rentals - Automotive EMC Immunity Test Equipment

ISO 7637 Test Equipment Rentals - Automotive EMC Immunity Test Equipment

Rent test equipment for ISO 7637 that defines testing parameters for electrical disturbances from conduction and coupling including that of electrical transient conduction along supply lines of vehicles. This automotive EMC testing standards consists of five components including ISO 7637-2. This standard is available for purchase at the ISO Website. It sets testing parameters for temperature, supply voltage, setup, measurement, test equipment, and many other factors. ISO 7637 is often referenced by manufacturer standards that require some modifications of waveforms to meet specific requirements. This standard specifies shapes and parameters for pulses and provides details about required electrical components. All of our automotive EMC Immunity testing equipment comes with an A2LA accredited calibration and provide turnkey solutions. ISO 7637 Test Pulses 5&7 - Automotive EMC Test Equipment Rentals 
ISO 7637 can be tested to with Automotive EMC Immunity Test Equipment and provides performance status classifications for immunity. The classification status is based upon the pulse severity level, minimum number of pluses, and burst cycle. The rating table based on these factors can be different for each kind of pulse, and for both 12 V and 24 V systems. ISO 7637-2 test equipment provides necessary information on test pulses 1, 2a, 2b, 3a, 3b and for 4, 5a, and 5b refers to ISO 16750-2 and ISO 21848. This EMC based standard also describes bench tests for both the injection and measurement of transients. Our ISO 7637 test equipment rentals provide capabilities to test to many manufacturer standards that are based off this standard.ISO 7637 Pulse and Pulse Parameters
ISO 7637 setup places special emphasis on the location of device under test (DUT), power supply lines, and location of load simulator. The DUT must be placed non-conductive support with a thickness of 50mm (+/-10%). For test pulses 3a & 3b it is necessary that the test pulse generator and DUT will be laid in a parallel line on a on-conductive support with a thickness of 50mm (+/-10%) with a length of (500 ± 100) mm.      ISO 7637 Immunity Setup
ISO 7637 requires unique test equipment to meet the variety of waveforms required. We rent automotive products from both Teseq and EM Test, leaders in EMC test equipment. Teseq makes the NSG 5500, an all-in-one solution for many of the pulses required by this standard. This versatile rental test equipment has a programmable power supply that can be rented along with the unit, the PA 5840. The EM Test products provide the ability to test for individual pulses, allowing rental customers who only need a single waveform for a more economical option. The UCS200n, LD200n, VDS200n, and Autowave by EM Test can be integrated for a complete immunity test system, similar to that of the NSG 5500. Our EMC test equipment rentals come with A2LA calibration & free technical support. NSG 5500 Components for ISO 7637

ISO 7637 Test Equipment Rentals - Automotive EMC Test Equipment

Showing 1 to 9 of 15 products

RENTAL

NSG 5500 Rental - Teseq Automotive Transient Generator

The Teseq NSG 5500 rental offers solutions for transient immunity testing based on ISO 7637 pulses 1, 2a, 3a, 3b, and the load dump pulses from ISO 16750-2.  It includes the +ARB Option for pulses 2b and 4. Our automotive EMC test equipment rentals include an accredited calibration in the rental price. This Teseq automotive transient generator includes a coupler/battery switch for testing requiring battery coupling.

The NSG 5500 system allows for testing to international, commercial, and company specific standards including. The Arbitrary waveform generator option supports >64,000 segments plus 1GB of Clone data with up to 10Ms/s 16 bit operation. Control of the testing parameters is done through PC running AutoStar™ software. This Teseq automotive immunity generator rental offers testing to be completed through a single output connector.

This turnkey product comes with a laptop with software pre-installed for efficient testing. Additional inputs and outputs are located on the rear panel for test execution control purposes and monitoring. It is the first product to offer a completely internal 100 amp. battery switch for transient immunity testing. The NSG 5500 rental transient immunity generators can be used with the PA 5840-300 battery Simulator or the PA 5840-75 Battery Simulator.

  

RENTAL

PA 5840 Rental - Teseq EMC Battery Simulator 25amp

The PA5840-75 by Teseq is an 25 Amp DC power supply for use with the Teseq NSG 5500 automotive EMC immunity test system. A2LA accredited calibration is included in the automotive EMI immunity test equipment rental price. This fast, reliable, and modular battery simulator and is designed to simulate 12, 24, and 42 V vehicle electrical systems. 

This Automotive EMC Test Equipment provides dips and interrupts for a diverse set of automotive EMI standards including ISO 7637, waveforms 2b and 4. The PA 5840 also allows for testing to military automotive immunity standards including MIL-STD-461E. This latest Teseq model has 4 quadrant operation, important in the EV environment.

The PA 5840 includes two gain settings for use and output ranges for power efficiency. This DC power supply needs a control unit to be used.This automotive transient immunity generators setup also allows for High bandwidth up to 150 kHz. To facilitate the most efficient testing we provide rentals of both the 100 amp and the PA 5840-300 100 Amp model.  

RENTAL

PA 5840 Rental - Teseq EMC Battery Simulator 100amp

The PA5840-300 by Teseq is an 100 Amp DC power supply for use with the Teseq NSG 5500 automotive EMC immunity test system. A2LA accredited calibration is included in the automotive EMI immunity test equipment rental price. This fast, reliable, and modular battery simulator supply comes with up to 18 kW of power and is designed to simulate 12, 24, and 42 V vehicle electrical systems. 

This Automotive EMC Test Equipment provides dips and interrupts for a diverse set of automotive EMI standards including ISO 7637, waveforms 2b and 4. The PA 5840 also allows for testing to military automotive immunity standards including MIL-STD-461E. This latest Teseq model has 4 quadrant operation, important in the EV environment.

The PA 5840 includes two gain settings for use and output ranges for power efficiency. This DC power supply needs a control unit to be used.This automotive transient immunity generators setup also allows for High bandwidth up to 150 kHz. To facilitate the most efficient testing we provide rentals of both the 100 amp and the PA 5840-75 25 Amp model.  

RENTAL

LD200N Rental - EM Test Load Dump Generator

The EM Test LD200N rental allows cost efficient testing to SAE J1455, SAE J1113, FMC1278, ISO 16750,  ISO 7637, wave forms 5 and 7. This automotive EMC test equipment simulates the sudden battery disconnection causing an over voltage impulse. A2LA accredited calibration is included in the rental. This standalone generator includes a 60 V/ 30A DC coupling/decoupling allowing for direct testing.

This immunity generator is an all in one system for testing high-energy pulses as required by ISO 7637. By means of a built-in clipping circuit it also generates clipped load dump pulses as per international standards as well as manufacturer requirements. The LD200N can be integrated with the UCS200N and VDS 200N for a complete automotive immunity test system, similar to the NSG 5500.  

This test equipment allows for both pre-programmed standard test and modification of individual pulses through the FreeStyle mode. It has an adjustable source impedance from, 0.5 Ω to 38 Ω in .1 Ω steps. To facilitate a turnkey solution, we include laptop with software with this rental arriving at the testing location ready for use.

RENTAL

UCS200N Rental - EM Test Automotive EFT Generator

The EM Test UCS200N rental unit  provides fast transient and microburst testing for SAE J1113JASO, and ISO 7637 waveforms 1,2,3a,3b. The built-in coupling network can be used and controlled by any unit of the LD200N series, VDS200N series and PFM200N series. A2LA accredited calibration is included in the EMC rental equipment price.

The UCS200N is equipped to meet all international and car manufacturer specifications from around the globe. Testing parameters can be modified easily through the display or via software. This Automotive EMC Test Equipment goes beyond standard's requirements waveform parameters of the Micropulse generator can be varied in a wide range by means of the FreeStyle mode.

This Teseq Automotive EMC generator includes an innovative color touch screen with intuitive menu structure and defined keys for Start / Stop / Pause, indicated by LED bars, enables the user to program test routines quickly and accurately. The UCS 200n50 also includes built in battery switch an over current protection for added testing safety. The UCS00n can be integrated with the LD200n and VDS200n  automotive transient immunity generators for a complete immunity test system, similar to that of the NSG 5500.

RENTAL

UCS200N100 Rental - EM Test Automotive EFT And Microburst Generator 100Amps

The UCS200N100 by EM Test is a fast transient and microburst generator for waveforms 1,2,3a,3b of SAE J1113, JASO, ISO 7637 and many others. The built-in coupling network can be used and controlled by any unit of the LD200N series, VDS200N series and PFS200N series. A2LA accredited calibration is included in the EMC rental equipment price.

The UCS200n100 series is equipped to meet all international and car manufacturer specifications from around the globe. Testing parameters can be modified easily through the display or via software. This Automotive EMC Test Equipment goes beyond standard's requirements waveform parameters of the Micropulse generator can be varied in a wide range by means of the FreeStyle mode.

An innovative color touch screen with intuitive menu structure and defined keys for Start / Stop / Pause, indicated by LED bars, enables the user to program test routines quickly and accurately. The UCS 200N100 also includes built in battery switch an over current protection for added testing safety. The UCS200N can be integrated with the LD200N and VDS200N for a complete immunity test system, similar to that of the NSG 5500.

RENTAL

VDS200n30 Rental - EM Test Automotive EMC Programmable Power Supply, 30 Amp

The EM Test VDS200n30 power supply, and Interrupts is designed for automotive EMC standards including ISO 7637, waveforms 2b an 4. This battery supply simulator and DC voltage source provides a diverse set waveforms recommended by both international and company standards. A2LA accredited calibration is included in the EMC rental equipment price.

This waveform generator can easily be integrated with the UCS 200n and the LD 200n for a complete immunity test system,  similar to that of the NSG 5500. It provides Current up to 200A (peak up to 1,000A) with low output impedance. The VDS 200n30 Automotive EMC Test Equipment also allows for both pre-programmed Standard Test and modification of individual pulses. 

RENTAL

VDS200n Rental - EM Test Automotive Power Supply Generator 15Amp

The EM Test VDS200N 15amp power supply rental is a effective solution for automotive testing including ISO 7637, waveforms 2b an 4. This battery supply simulator and DC voltage source provides a diverse set waveforms recommended by both international and company standards. A2LA accredited calibration is included in the EMC rental equipment price.

The VDS 200N Automotive EMC Test Equipment also allows for both pre-programmed Standard Test and modification of individual pulses. The EM Test iso.control software provides fast control of all test parameters providing and efficient and effective testing solution. This rental equipment comes will all required cords and software required to complete testing.

This automotive waveform generator can easily be integrated with the UCS200and the LD200N automotive transient immunity generators for a complete automotive test system, similar to that of the NSG 5500. It provides Current up to 200A (peak up to 1,000A) with low output impedance. The VDS 200n provides unique testing capabilities and easy to use interface, making it ideal for a variety of automotive immunity testing needs.

RENTAL

CA EFT kit Rental - EM Test Automotive EFT Verification kit

This product made by EM Test is a set of Adapters for verifying EFT/Burst generators. The pulse shape of EFT/burst generators designed as per IEC 61000-4-4 have to be verified both into a 50ohm and a 1,000ohm load at the 50ohm coaxial HV output as well into 50ohm load at the output of the coupling network where the DUT is connected when testing mains supply lines. The CA EFT kit includes the load resistors and a set of adapter to connect the coaxial matching resistors appropriately to the DUT output port.

Showing 1 to 9 of 15 products