TRA3000 Accesories

RENTAL

Coupling Clamp (CCL) Features 

      • New design, Includes Safety Cover & Interlock
      • ISO 17025 Calibration & 2 Days Free Transit
      • Compliant IEC 61000-4-4 Ed.2 & Ed.3
      • Can Work With Many Immunity Generators!
      • Replaces CDN 8014 and CDN 8015
      • Turnkey Solution - Arrives Ready for Testing!

Overview

The Teseq CDN3425 (Teseq CCL) main purpose is to couple Burst/EFT pulses to data lines. It can also be used to couple to mains lines where no CDN is available; for example, high current lines >200 A. This coupling decoupling network (CDN) capacitive coupling clamp (CCL) comes with an ISO 17025 accredited calibration and works with a many conducted immunity generators

The new design is fully compliant with the specifications of IEC 61000-4-4 Ed 2.0 2004, as well as with the draft of EN/IEC 61000-4-4 Ed 3.0 to be published in 2012. This model also replaces earlier models CDN 8014 and CDN 8015.The coupling capacitance between the coupling clamp and the cable laid in it depends on the cable characteristics. 

RENTAL

In Stock

Coupling Clamp (CCL) Features 

      • Thermo Keytek Design Includes Cords
      • ISO 17025 Calibration & 2 Days Free Transit
      • Compliant IEC 61000-4-4 Ed.2 & Ed.3
      • Can Work With Many Immunity Generators!
      • Turnkey Solution - Arrives Ready for Testing!

Overview

The capacitive coupling clamp by Thermo-Keytek is designed for EFT pulses on I/O lines or data lines per EN/IEC 61000-4-4. This equipment is fully compliant with the specifications of IEC 61000-4-4 Ed 2.0 2004, as well as with the draft of EN/IEC 61000-4-4 Ed 3.0 published in 2012. These testing accessories have the capabilities to work with a variety of conducted immunity generators from many manufacturers, making it an ideal solution. 

RENTAL

In Stock

Pearson Model 110 Current Probe.  Donut shaped for current monitoring up to 5000 Amps .1 Volts per Amp. attenuation.

RENTAL

In Stock

The Teseq CAS3025 burst/EFT pulse verification kit has been specially designed to comply with the new requirements of IEC/EN 61000-4-4:2004 to enable EMC engineers to verify their burst/EFT test generators periodically. Many EMC standards call for a verification of the test equipment before and after every test session. If the verification shows differing results, no valid test results can be assumed and the test equipment has to be re-calibrated.

RENTAL

Thermo Keytek PK 1001 D 6kV high voltage differential probes have BNC connectors to the 2 channels of the oscilloscope and clip leads for measuring output.

RENTAL

Thermo Keytek PK 1002 D 10kV high voltage differential probes have BNC connectors to the 2 channels of the oscilloscope and clip leads for measuring output.